(2) Strange ADC102 Cambered drive flanges 5x5 pattern NASCAR Late Model

Description

(2) Strange cambered drive flanges for Monster Energy CUP car.  Strange Cup model.  2 piece gear style for camber.   Complete kit.  Includes Seals It seals.  Ready to bolt in!  Normally sell for 9 each!
Our spline tolerances, between the axle splines and drive plate splines, is usually tighter and more uniform. These “closely mated” tolerances will provide better spline life of both the axles and drive plates. Strange Oval offers several steel drive plates that will accommodate a camber range of zero to 4 degrees. Depending on where your current rules regarding allowable camber lies (if any)
Nickel Chromium Molybdenum steel for excellent hardenability, strength, and toughness to provide good spline wear and drive flange longevity
FEA (Finite Element Analysis) analyzed lightweight scalloped and pocketed design
Dry film solid lubricant applied to insert gear to prevent galling and increase lubricity
Marquenching heat-treat processing reduces distortion and residual stress
electropolishing enhances surface finish especially beneficial on the spline flanks for reduced friction, reduced wear, and lower operating temperatures
Broached splines promote consistent fit and misalignment angle
2 piece drive plate #ADC102 can be run with standard crowned spline axles and can accommodate 0 to 3.5 degrees of camber with the articulating splined insert. This drive plate must be used with the standard crowned splined axles (not straight splined axles – see drive plate ADC102)
Purchase at the fraction of the cost of new.
See other carbon fiber and brake parts in our store:  Used Race Parts Supply.